1/2-Inch Drive Click Torque Wrench 10~150 Ft-Lb/13.6~203.5 Nm (LX-183)

Yes, if the specified clockwise tightening torque is between 10 and 150 ft-lb and you have the correct socket. Use your vehicle maker's torque value rather than a generic lug-nut setting.

Yes, when the wheel maker's required clockwise torque falls within 10-150 ft-lb. Match the socket to the fastener and follow the maker's tightening and recheck procedure.

Yes, when the service-manual torque is within 10-150 ft-lb and tightening is clockwise. Check the required socket size and available working space before choosing this 17-inch wrench.

No. LX-183 has a 1/2-inch square drive, so a 3/8-inch drive socket does not attach directly.

No, not below its 10 ft-lb minimum. Choose a lower-range torque tool that includes the fastener's specified torque.

No. The ratchet head reverses, but calibrated torque measurement is clockwise only.

Yes. The rated range is 10-150 ft-lb, and 150 ft-lb is the upper limit; use another wrench for specifications above that.

Yes. The body has ft-lb and Nm scales, with a stated range of 10-150 ft-lb or 13.6-203.5 Nm.

No. Each micrometer increment represents 1 ft-lb, approximately 1.36 Nm, rather than 1 Nm.

No. The click signals the selected torque, but you must stop pulling and release pressure immediately.

No. The manual prohibits loosening stuck fasteners and adding devices to increase leverage.

No. At low settings it can be subtle, so pull slowly and learn to recognize it by feel as well as sound.

Both have a 1/2-inch drive and calibrated clockwise measurement. LX-183 covers 10-150 ft-lb with a 17-inch length; LX-184 covers 25-250 ft-lb with a 25-inch length. Choose the range and access needed for your fastener.

No, not for settings below 10 ft-lb. Choose by the required torque range and socket drive, not by the appearance of the wrench.

Yes. The listing specifies pre-calibration to +/-4% and a certificate with a traceable serial number; check your own certificate for its calibration date.

With storage at low settings in an appropriate environment, Lexivon gives expected accuracy of 5,000 clicks, about two years from first use. This is not a guaranteed calibration month, a fixed workplace interval or an extension of defect coverage.

No. The product kit shows the wrench, case and calibration certificate, and the click mechanism operates manually without batteries.

No. The published policy provides 12 months standard coverage, extended to 24 months total by registration within 90 days; commercial use is limited to 12 months and industrial use is excluded.

Yes. Unlock the bottom knob, align the main scale to 90 ft-lb and the micrometer zero, then turn the handle to the 5 mark and lock the knob snugly by hand.

No. At low settings the signal may be subtle; practice slowly on a non-critical application and stop at the first felt or audible click.

No. Set and snug the locking knob by hand; if the setting still moves, stop and contact Lexivon instead of trusting the reading.

No. Store at the lowest marked setting, 10 ft-lb, with the micrometer at zero, and never turn the handle below that minimum.

No. The manual recommends operating it several times at a low setting after an extended period without use, then checking the intended setting before the job.

Use a calibration laboratory that you or your employer trust. Lexivon does not offer recalibration services, and recalibration is excluded from the defect warranty. Confirm the laboratory can provide the documentation your work requires.